Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manual do Utilizador descarregar pdf (Página 119)

Installing under OS/400

TCP/IP AX3000 User's Manual 109

b) Under OS/400

The whole AX3000 set-up can be obtained by invoking the following command:

===> RUNRMTCMD CMD(SETUP_GET) RMTLOCNAME('192.168.1.241' *IP)

or a partial set-up can also be obtained (only used set-up parameters are sent):

===> RUNRMTCMD CMD(SETUP_GET_LITE) RMTLOCNAME('192.168.1.241' *IP)

Where:

- SETUP_GET : command for getting the whole set-up,

- SETUP_GET_LITE : command for getting the partial set-up,

- 192.168.1.241 : AX3000 IP address.

For more information about these commands, refer to Chapter 10.

6.4.4 - Setting-Up the AX3000

No OS/400 command allows the contents of a set-up file to be sent over the

network. The following example describes the use of rsh Windows command:

c:\> rsh 192.168.1.241 setup_send password < /tmp/axel

Where:

- 192.168.1.241 : AX3000 IP address,

- setup_send : command for set-up the AX3000,

- password : specify the set-up password if set.

For more information about this command, refer to Chapter 10.

6.4.5 - Downloading a Firmware

To download an AX3000 firmware through TFTP:

===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')

RMTLOCNAME('192.168.1.241' *IP)

To download an AX3000 firmware through BOOTP and TFTP:

===> RUNRMTCMD CMD('AX_DOWNLOAD password /axfirm/ax3000 192.168.1.180')

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 239 240

Sem comentários

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manual do Utilizador Página 119